MOJAB 1/4 inch x 24 inch UHMWPE soft shackle set of 2 for UTV recovery

ATV/UTV CVT Clutching

Soft Shackle vs D-Ring Shackle: UTV Recovery Shackle Guide

Previous

Soft Shackle vs D-Ring Shackle: UTV Recovery Shackle Guide

Next

Every recovery on a side-by-side has a weak point you can control: the connection. Today you have two main choices, a synthetic soft shackle or a metal D-ring shackle in steel or aluminum. Both work, but they suit different jobs, and picking the wrong size for a UTV is one of the most common mistakes we see. This guide covers how each type works, how to size a recovery shackle for a side-by-side, and how to use and care for it, using the shackles we carry and the ratings their makers list.

What a recovery shackle does

A shackle is the link between your recovery point and whatever is doing the pulling: a kinetic rope, a tow strap, a tree saver or a winch line. It has to hold the full load of the pull without opening, bending or breaking, and it has to fit through your machine's recovery point. On many UTVs those points are smaller than on a truck, so a shackle that looks tough on the shelf may not fit.

Two ratings show up on every shackle we sell:

  • MBS (minimum break strength): the load where the shackle is expected to fail.
  • WLL (working load limit): the load you should stay under in normal use. It is set well below the MBS to leave a safety margin.

Size your gear by the WLL, not the MBS. As a rule, every piece in the chain, from the shackle to the rope to the strap, should have a working rating at or above what the pull will put on it, so no single piece becomes the weak link.

Soft shackles: how they work

A soft shackle is a loop of synthetic rope with a knot on one end. You pass the loop through your recovery point and around the rope eye, push the knot through the loop, then pull the loop tight to lock it.

The soft shackles we carry from MOJAB are made from UHMWPE, the same family of fiber used in synthetic winch rope. Why riders like them:

  • Light weight. A soft shackle weighs a fraction of a metal shackle, which matters when you are carrying recovery gear on a UTV.
  • Less flying metal. Freedom Ropes points out that soft shackles remove the flying-metal risk of a steel shackle if something lets go under load.
  • Flexible fit. A soft shackle can wrap around odd shaped mounts, tow hooks and rope eyes that a rigid shackle will not fit through.

The trade-offs are real too. Synthetic fiber can be cut by sharp edges and rough metal, and it does not like heat or long storage in direct sun. Keep soft shackles away from burrs on recovery points and inspect them before every use.

D-ring shackles: steel vs aluminum

A metal D-ring shackle, also called a bow or D-shackle, has a U-shaped body and a threaded pin. You slip the body over the recovery point, run the pin through and screw it in.

Forged steel is the traditional choice. The MOJAB 3/4" Forged Steel D-Shackle Set (8 Ton) is galvanized and powder coated, with a listed MBS of 60,000 lbs and a WLL of 16,000 lbs. The set includes 2 rubber isolators, 4 rubber washers and 2 R-clips to hold the center pin, so the shackle stays quiet and does not rattle against your mount when you leave it installed.

Aluminum cuts the weight while keeping a high rating. The MOJAB 3/4" Aluminum D-Shackle Set (9 Ton) is machined from T6-6061 aluminum with a ceramic coating. MOJAB lists a 70,000 lb MBS and an 18,000 lb WLL, a 5 inch length, a 3 inch width outside to outside, a 1.23 inch inside opening between the legs and a 7/8 inch steel pin.

Those numbers show why fit matters. Before you buy any D-ring shackle for a side-by-side, measure the hole in your recovery point and the thickness of the tab, and compare them to the pin size and leg opening. If the pin will not pass through the hole, the shackle will not work on that machine no matter how strong it is.

Sizing a shackle for a UTV

The easiest way to get this wrong is to buy the biggest shackle you can find. A shackle that is too thick will not fit the smaller recovery points found on many side-by-sides, and it adds weight you have to carry.

Here is how the soft shackles we carry compare, based on MOJAB's listed ratings:

Shackle Size WLL MBS What MOJAB says it is for
Micro Soft Shackle 3/16" x 6" 2,900 lbs 8,600 lbs Light rigging, winch accessories, hanging gear, keychain
Soft Shackle Set of 2 1/4" x 24" 4,400 lbs 13,000 lbs UTVs, ATVs and lightweight off-road setups
Long Reach Soft Shackle Set of 2 3/8" x 35" 10,700 lbs 32,000 lbs Easier rigging around axles, frames and recovery points

For most side-by-side owners, the MOJAB Soft Shackle 1/4" x 24" Set of 2 is the right starting point. MOJAB sizes it for UTVs, ATVs and lightweight setups, and the set comes with two shackles and a storage bag, so you can rig both ends of a rope. It carries a lifetime warranty.

If you need more reach, the MOJAB Long Reach 3/8" x 35" Soft Shackle Set of 2 is longer than a standard shackle, which makes it easier to wrap around a frame member, an axle or an awkward recovery point. Each one has a red protective sleeve to guard against abrasion on the trail. It is also a heavier rated shackle, so check that it fits your recovery point the same way you would a metal one.

The MOJAB Micro Soft Shackle 3/16" x 6" is handy for clipping a winch hook strap, hanging a recovery bag or other light rigging. MOJAB is clear that it does not replace a full size recovery shackle, so do not use it to connect a kinetic rope or a winch line for a real pull.

Soft shackle or D-ring: which should you carry?

  • Go soft if you want light gear, you mostly pull with a kinetic rope or synthetic winch line, and your recovery points are smooth and free of sharp edges.
  • Go aluminum if you want a rigid shackle that can live on your bumper or hitch mount without the weight of steel, and your recovery points are sized for it.
  • Go forged steel if you want the most abuse-tolerant option and do not mind the extra weight, or you want isolators to keep a mounted shackle quiet.

Plenty of riders carry both: a pair of soft shackles in the bag for rope and winch work, plus one metal shackle for spots where a rough or sharp mount could damage rope.

How to use a shackle safely

  1. Check the rating. Make sure the WLL of the shackle is at or above the working rating of the rope or strap you are using.
  2. Use a real recovery point. Connect to a frame-mounted recovery point, never to a tie-down, a bumper skin, suspension parts or a ball hitch.
  3. Lock it fully. On a soft shackle, pull the loop snug around the knot before loading it. On a D-ring, screw the pin in until it is fully seated.
  4. Load it straight. Keep the pull in line with the shackle body. Side loading a D-ring or twisting a soft shackle around a sharp corner reduces what it can hold.
  5. Clear the area. Keep everyone well back from the line during the pull, and drape a recovery damper or a heavy jacket over the rope if you have one.
  6. Inspect after every pull. Look for cuts, fuzzing, melted or stiff spots on soft shackles, and for bends, cracks or a stuck pin on metal ones. Retire anything that is damaged.

Caring for your shackles

Rinse mud and sand off soft shackles with fresh water after a ride, let them dry fully and store them in their bag, out of direct sun. For metal shackles, wipe them clean, keep the pin threads free of dirt and check the coating for chips that could let rust in.

A shackle is one piece of a full recovery setup. For the rest of the kit, see our UTV recovery kit guide and our guide to UTV winch accessories.

Shop recovery shackles

You can see every soft shackle, D-ring shackle, kinetic rope, strap and traction board we carry in our Off-Road Recovery Gear collection. Shipping is free in the US and takes 3 to 7 business days. If you are not sure which shackle fits your machine's recovery points, call us at 662-631-9254 or email msautodetail@outlook.com and we will help you pick the right one.

By Fix N Offroad